您好,欢迎来到61ic! | [登录] [注册] 忘记密码 | 设为首页 帮助
 . 网站首页 . 业界新闻 . 设计中心 . 移动技术 . TI专栏 . ADI专栏 . FPGA专栏 . 代码工厂 . 官方商城 . 
 . 活动专区 . 新品快递 . 解决方案 . 前沿科技 . TI资源 . ADI资源 . FPGA资源 . 下载中心 . 产品展示 . 
加入收藏
付款方式
联系我们
您现在的位置: 61IC电子在线 >> TI专栏 >> TI模拟设计 >> 模拟设计 >> 正文
  [组图]TI TPS1H100-Q1汽车车体控制模块驱动器(BCM)参考设计           ★★★ 【字体:
TI TPS1H100-Q1汽车车体控制模块驱动器(BCM)参考设计
作者:TI    文章来源:TI    点击数:    更新时间:2015-4-9    
TI公司的TPS1H100-Q1是全保护的高边功率开关,集成了NMOS功率FET和电荷泵,工作电压3.5V-40V,待机电流小于0.5uA,工作温度–40 到150℃,适合各种电阻,电感和电容负载,主要用在汽车电子如HVAC,车体控制模块,超声辅助停车,汽车干式双离合器变速器和车载全景可视系统.本文介绍了TPS1H100-Q1主要特性,框图,典型应用电路图以及汽车车体控制模块驱动器(BCM)参考设计TIDA-00296主要特性,框图,电路图和材料清单.

The TPS1H100-Q1 is a fully protected high-side power switch, with integrated NMOS power FET and charge pump, targeted for the intelligent control of the variable kinds of resistive, inductive, and capacitive loads. Accurate current sense and programmable current limit features differentiate it from the market.

TPS1H100-Q1主要特性:
Qualified for Automotive Applications
AEC-Q100 Qualified With the Following Results:
Device Temperature Grade 1:–40℃ to 125℃ Ambient Operating Temperature Range
Device HBM ESD Classification Level H3A
Device CDM ESD Classification Level C4B
Single-Channel Smart High-Side Power Switch With Full Diagnostics
Version A: Open-Drain Status Output
Version B: Current Sense Analog Output
Wide Operating Voltage 3.5 to 40 V
Very-Low Standby Current, <0.5 µA
Operating Junction Temperature, –40 to 150℃
Input Control, 3.3-V and 5-V Logic Compatible
High-Accuracy Current Sense, ±30 mA at 1 A, ±4 mA at 5 mA
Programmable Current Limit With External Resistor, ±20% at 0.5 A
Diagnostic Enable Function for Multiplexing of MCU Analog or Digital Interface
Tested According to AECQ100-12 Grade A, 1 Million Times Short to GND Test
Electrical Transient Disturbance Immunity Certification Certification of ISO7637-2 and ISO16750-2
Protection
Overload and Short-Circuit Protection
Inductive Load Negative Voltage Clamp
Undervoltage Lockout (UVLO) Protection
Thermal Shutdown/Swing With Self Recovery
Loss of GND, Loss of Supply Protection
Reverse Battery Protection With External Circuitry
Diagnostic
On/Off State Output Open/Short to Battery Detection
Overload and Short to Ground Detection and Current Limit
Thermal Shutdown/Swing Detection
14-Pin Thermally-Enhanced PWP Package
TPS1H100-Q1主要应用:
Automotive - HVAC
Body Control Module
Ultrasonic Park Assist
Automotive Dry Double Clutch Transmission
Surround View

图1. TPS1H100-Q1框图

图2. TPS1H100-Q1典型应用电路图

汽车车体控制模块驱动器(BCM)参考设计TIDA-00296

TIDA-00296 is a reference design that highlights TI’s high-side and low-side relay, motor, and load driver portfolios. The loads for this design (door locks, window lifts, seat heaters, HVAC, lamps, and LEDs) were chosen to show the range of loads that a BCM can drive and how TI’s solutions fit into these areas.

BCM参考设计TIDA-00296主要特性:

Robust and versatile driver products for driving various loads:
High-side pre-FET Drivers (LM9061/TPIC44H01)
Seat Heaters
Low-Side Driver (TPL7407L)
Lamps
High-Side Driver (LMD18400/TPS1H100-Q1)
HVAC Blower, Window/Windshield Actuators
Linear LED Driver (TPS92630)
LEDs
Smart drivers have diagnostic and protection capabilities via I2C and SPI
Reverse polarity protection on the power stage of the design
pre-FET drivers are used to drive discrete FETs allowing the design to have flexibility with load driving requirementsHighlights the ability of the BCM to directly drive loads with higher current requirements (~4500mA)
TIDA-00296 Board
图3. BCM参考设计TIDA-00296板外形图

图4. BCM参考设计TIDA-00296板框图

图5. BCM参考设计TIDA-00296板电路图(1)

图6. BCM参考设计TIDA-00296板电路图(2)

图7. BCM参考设计TIDA-00296板电路图(3)

图8. BCM参考设计TIDA-00296板电路图(4)

图9. BCM参考设计TIDA-00296板电路图(5)

图10. BCM参考设计TIDA-00296板电路图(6)

图11. BCM参考设计TIDA-00296板电路图(7)

图12. BCM参考设计TIDA-00296板电路图(8)

图13. BCM参考设计TIDA-00296板电路图(9)

图14. BCM参考设计TIDA-00296板电路图(10)
BCM参考设计TIDA-00296板材料清单:

详情请见:
http://www.ti.com/lit/ds/symlink/tps1h100-q1.pdf
http://www.ti.com/lit/df/tidram2a/tidram2a.pdf
以及http://www.ti.com/lit/ug/slvuab4/slvuab4.pdf

slvuab4.pdf
tidram2a.pdf
tps1h100-q1.pdf
文章录入:admin    责任编辑:admin 
  • 上一篇文章:

  • 下一篇文章: 没有了
  • 发表评论】【加入收藏】【告诉好友】【打印此文】【关闭窗口
    最新热点 最新推荐 相关文章
    TI发布业内首个用于模拟设计…
    TI UCC28730零待机功耗大功率…
    TI MSP430F522x系列MCU蓝牙和…
    为何要谨慎地增加音频处理系…
    TI TPS23754 Class 4 PoE电源…
    TI UCC28710输出28V 350W电源…
    TI宣布其基于KeyStone的AM5K…
    TI TPS23754 Class 4 PoE电源…
    TI bq5102x WPC 5W无线电源接…
    TPA6132A2正相单端放大器电路…
      网友评论:(只显示最新10条。评论内容只代表网友观点,与本站立场无关!)
    站长:61 湘ICP备13001086号-2